Asking being I just had take out about 40 screws and disconnect several board connectors to replace a simple damaged motor gear. Took a few hours for something that could easily take minutes to repair with a little thoughtful manufacturer design.

  • reddig33@lemmy.world
    link
    fedilink
    arrow-up
    11
    ·
    edit-2
    10 months ago

    The low end Roomba is simple to repair. There are lots of YouTube videos you can watch about disassembly and gearbox cleaning. The battery is easy to replace as well. The only bad thing about its design is it’s made from plastic. In eight years or so you might need to replace the brush cage or a similar part. Plastic loses its flexibility and gets brittle over time, so some parts like this might split or crack.

    • remotelove@lemmy.ca
      link
      fedilink
      arrow-up
      4
      ·
      10 months ago

      I just did a quick search on Printables and there are quite a few mods and replacement part designs out in the wild. After looking at my Roomba, most of the major parts look easy to reverse engineer and reprint if needed.