IPv6 does not require you to open your machine to the Internet, even without making use of a NAT. Sure you get an IP that’s valid on the whole internet, but that doesn’t mean that anyone can send you traffic.

Are these restrictions set out by the ISP or the dorm?

If you don’t do business with the ISP, then you don’t have to agree to and follow their terms.

So as long as the dorms doesn’t have rules against setting up your own WiFi, then you should be well within your rights to purchase an Internet connection from another provider, but since you are likely not allowed to get your own line installed, you are probably restricted to ISPs that provide a service over the cellular network.

Of course using a cellular connection will give you worse latencies for online games, but at least you can have your own WiFi with low latency for your VR.

If you want to be nice, you could then run as much of your Internet network over ethernet as possible, so you congest the air waves as little as possible, possibly only running the VR headset over WiFi, and maybe even only enabling the WiFi radio when you want to play VR. If all your WiFi devices support 5GHz, you might also completely disable your 2.4GHz WiFi, to leave the most congested frequencies alone.

To lower the chance of someone complaining about your WiFi, you should configure it as a “hidden network”, such that it doesn’t broadcast an SSID, and therefore doesn’t show up when people are looking for WiFi networks to connect to.

I really don’t see much benefit to running two clusters.

I’m also running single clusters with multiple ingress controllers both at home and at work.

If you are concerned with blast radius, you should probably first look into setting up Network Policies to ensure that pods can’t talk to things they shouldn’t.

There is of course still the risk of something escaping the container, but the risk is rather low in comparison. There are options out there for hardening the container runtime further.

You might also look into adding things that can monitor the cluster for intrusions or prevent them. Stuff like running CrowdSec on your ingresses, and using Falco to watch for various malicious behaviour.

No need for a physically separated network, that’s what VLANs are for

That sound like you need a more serious setup, where you can control the network priorities and set a QoS, so the devices that you use interactively get priority over the other devices.

So as far as I understand, you have

• Outer router (Comcast), which has WiFi enabled
• Inner router (your own), which has WiFi enabled, and further meshes with other WiFi mesh devices (or is the mesh separate?)
• A plain switch, for stuff you want cabled and fast

Is that correct?

Why not get the WiFi in the Comcast router disabled, and use your inner network exclusively, such that both WiFi and ethernet devices are on the same network?

That’s what I did with my network, and I even got the ISP to put their modem/router into bridge mode, so it’s completely transparent.

That makes perfect sense, and switching is definitely annoying then… But the person I responded to said they had multiple WiFi networks at home… E.g. Not on holiday

Why on earth would you have multiple WiFi networks in your home?

I have a few cheap cameras that can handle both WiFi and ethernet, they support an SD card, and they do continuous recording regardless of connection type.

ZFS doesn’t really support mismatched disks. In OP’s case it would behave as if it was 4x 2TB disks, making 4 TB of raw storage unusable, with 1 disk of parity that would yield 6TB of usable storage. In the future the 2x 2TB disks could be swapped with 4 TB disks, and then ZFS would make use of all the storage, yielding 12 TB of usable storage.

BTRFS handles mismatched disks just fine, however it’s RAID5 and RAID6 modes are still partially broken. RAID1 works fine, but results in half the storage being used for parity, so this would again yield a total of 6TB usable with the current disks.

SSD longevity seems to be better than HDDs overall. The limiting factor is how many write cycles the SSD can handle, but in most cases the write endurance is so high that it’s unreachable by most home/NAS systems.

SSDs are however really bad for cold storage, as they will lose the charge stored in their cells if left unpowered too long. When the SSD is powered it will automatically refresh the cells in the background to ensure they don’t lose their charge.

Factorio. I saw transport belts in my dreams.

Nope, those steps are the steps needed to legally watch Netflix on Asahi Linux on an Apple Silicon device, because Google has not officially released the widevine library for that platform

But the author is actually using less data than expected, because he’s paying for 4K, but only able to watch up to 1080p

Agreed, and this is what I have set up for mine… But this is also technologically so far out of reach for >95% of people…

My home-assistant installation alone is too much for my Raspberry Pi 3. It depends entirely on how much data it’s processing and needing to keep in memory.

Octoprint needs to respond in a timely manner, so you will want to have the system mostly idle (at least below 60 percent CPU at all times), preferably octoprint should be the only thing running on the system unless it’s rather powerful.

If I were you, I would install octoprint exclusively on your Raspberry Pi 3, and then buy a Raspberry Pi 4 for the other services.

I’m running Pi-hole and a wireguard VPN on an old Raspberry Pi 2, which is perfectly fine if you are not expecting gigabit speeds on the VPN.

As a Software Engineer, I ask myself that question several times per day.

Yeah, there’s tonnes of good content on there, but as you allude to, there’s even more shitty or zero effort content… And the algorithm has a way of serving up absolute trash. And the parental controls are pretty much non existent…

Youtube happily serves up videos to an 8 year old (on a supervised children’s account) that contain topics like abuse, sex, racism, horror, radical religious indoctrination, Chinese propaganda, and human centipede… This isn’t as rampant in the YouTube Kids app… But at least half the stuff on YouTube Kids is ASMR content or unboxing “surprise” toys…

YouTube allows you to block channels, but will happily continue serving the 9000 other accounts that simply reupload the same exact videos.

Open-source EVs are a bit like Gentoo, you have to build it yourself.