Hi there ! I have a little box at home, hosting some little services for personal use under freebsd with a full disk encryption (geli). I’m never at home and long power outage often occurs so I always need to come back home to type my passphrase to decrypt the disk.

I was searching this week a solution to do it remotely and found the “poor-guy-kvm” solutions turning a Raspberry like board (beaglebone black in my case) in a hid keyboard. It works fine once the computer has booted but once reboot when the passphrase is asked before it loads the loader menu, nothing. When I plug an ordinary USB keyboard I can type my passphrase so USB module is loaded.

Am I missing something ? Am I trying something impossible ?

(I could’ve asked on freebsd forum but… Have to suscribe, presentation, etc… Long journey)

  • plague-sapiens@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    11 months ago

    What? xD The script used the DSL modems IPv6 WAN IP to set up the IPv6-to-IPv4 tunnel (to get IPv4 working) each time my ISP dropped the connection after 24h (standard DSL procedure over here in DE) or rnd reconnection. But somehow that script triggered a higher latency and probably packet loss/delay (couldn’t measure it, cause it only appeared in fast paced shooters like MW2019). Without the script everything ran fine except IPv4 after disconnections, which had to be setup manually. After that I sent the DSL modem back and returned to my AVM FritzBox as my main router. Can’t really say if it was directly the scripts fault or sth else in my OPNsense setup (low powered CPU, USB ethernet adapter, 4 port gbit LAN PCIe card, defective RAM, …). Maybe I’ll try a similar setup again some time, because I kinda liked OPNsense…